Thorax Airbag Crash Sensor In The Driver/Front Passenger Side B-Pillar G1101/G1102, Removing And Installing: Removing
The Thorax Airbag Crash Sensor in the Driver Side B-Pillar - G1101- and Thorax Airbag Crash Sensor in the Front Passenger Side B-Pillar - G1102- will be called the crash sensors in the information that follows.
The following information describes the removing and installing on the left side of the vehicle as an example.
-- Switch off the ignition and electrical equipment.
-- Place the vehicle key and other start authorization systems (such as smartphones) outside of the vehicle interior.
-- Remove the front sill panel. Refer to Front Sill Panel, Removing and Installing .
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Remove the bolt -arrow-.
-- Remove the crash sensor -1-.
-- Disconnect the connector -2-.
-- To do this, pull the connector lock -2- out and press it down in the -direction of the arrow-.