Electric Drive Power And Control Electronics 2 JX4, Removing And Installing: Installing
-- Replacing the seal -1-.
-- Replace the alignment pin -2-.
-- Remove the coolant connecting piece -3- from the three-phase current drive.
-- Carefully clean the opening for the coolant connecting piece on the three-phase current drive and on the power electronics.
-- Coat the new coolant connecting piece -3- with lithium lubricating grease and insert in the three-phase current drive.
Lithium lubricating grease. Refer to Parts Information.
-- Position the power electronics -1- on the three-phase current drive. At the same time pay attention to the alignment pin and the coolant connecting piece -arrows-.
-- Install the bolts -arrows- evenly hand-tight in a diagonal sequence.
-- Tighten the bolts -arrows- to the required tightening specification.
-- Tighten the bolts -1- for the busbars.
-- Position the new cover -1- and tighten the bolts -arrows- evenly in a diagonal sequence.
Further installation is performed in reverse order of removal, while noting the following:
If the Electric Drive Power and Control Electronics 2 -JX4- was replaced:
-- Perform the necessary Function/Functions using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .
Continuation