Parking Lock Solenoid -N486- /Drive Position Sensor -G676-, REMOVING AND INSTALLING: Installing

Courtesy of AUDI OF AMERICA, LLC

-- Check, if the splines of the Drive Position Sensor -G676- are flush with the splines of the parking lock shaft.

-- Tighten the bolt -arrow- to the tightening specification.

Courtesy of AUDI OF AMERICA, LLC

• Pay attention when installing the Parking Lock Solenoid -N486- that the alignment pin is seated correctly.

  Courtesy of AUDI OF AMERICA, LLC

-- Install both bolts -arrows- with lightened spring force and tighten to the tightening specification.

Courtesy of AUDI OF AMERICA, LLC

-- To do this using a pin punch shaft turn the parking lock approximately 3° against the spring force.

• Pay attention to the correct installation position!

  Courtesy of AUDI OF AMERICA, LLC

• The lever from the parking lock is flush to the shaft splines -arrow-.
• If necessary align with less spring force!

Tip:

• If necessary the spring pin can also be pushed in using pliers.
• Never drive in the tensioning pin because the shaft will be damaged.

-- Press the tensioning pin -1- in using the : T40437  -A- and : T40437/1  -B-.

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Install the catalytic converter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the particulate filter. Refer to PARTICULATE FILTER, REMOVING AND INSTALLING .

-- Install the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .