Parking Lock Shaft Seal, Replacing

Special tools and workshop equipment required

Procedure

4-Cylinder Vehicles TFSI Engine:

-- If installed, remove the particulate filter. Refer to the appropriate service information .

-- Remove the coolant pipes for the transmission. Refer to the appropriate service information .

4-Cylinder Vehicles TDI Engine:

-- Remove the coolant pipes for the transmission. Refer to the appropriate service information .

Vehicles with a 6-Cylinder Diesel Engine TFSI Engine:

-- Remove the catalytic converter. Refer to the appropriate service information .

All Vehicles:

-- Press the tensioning pin -1- out using the : T40437 -A- and remove the parking lock lever.

Courtesy of AUDI OF AMERICA, LLC

Depending on the transmission, the parking lock lever may be installed in various positions. See the illustrations above and below.

-- Remove the bolt -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -3-.

-- Remove the bolts -arrows- and the parking lock cover -1-.

-- Remove the seal with the :T10040/3 .

Courtesy of AUDI OF AMERICA, LLC

-- Press in the new seal with the :T10040/3 to the installation dimension 0.5 mm.

-- Install the catalytic converter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the particulate filter. Refer to PARTICULATE FILTER, REMOVING AND INSTALLING .

Tightening Specifications