ATF, Draining And Filling
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Used Oil Collection and Extraction Unit :SMN372500
- Pressurized Gearbox Oil Filler Kit :VAS6617 with Pressurized Gearbox Oil Filler - Hand Pump :VAS6617/1 and Pressurized Gearbox Oil Filler - Adapter 2 :VAS6617/2
- Pressurized Gearbox Oil Filler Kit - Adapter :VAS6617/12
- Protective Eyewear
- Acid-Resistant Safety Gloves
The 7-speed dual-clutch transmission is equipped with an ATF and MTF chamber.
The ATF is located in the blue section of the transmission and is drained through the ATF drain plug -1- and filled through the ATF filler plug -2-.
The MTF is located in the green section of the transmission fluid and is drained by removing the MTF pump -4- and is filled through the MTF check plug -3-.
The bolt on the gear set -arrow- is not a drain plug.
Draining
Replace the plugs after removal.
- The engine is off.
- Move vehicle onto a four-pillar workshop hoist or over a work pit so that it is absolutely horizontal.
- The selector level is in "P".
- The parking brake button is pressed to activate the electro-mechanical parking brake.
-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Remove the bolts -arrows- and nut -2-.
-- Remove the crossbrace end panel -1-.
-- Place the :SMN372500 underneath.
-- Connect the Vehicle Diagnostic Tester with the vehicle and start the Diagnostic mode.
- Select vehicle test
- 0002-Transmission electronics, Guided Functions
- 0002-ATF level, checking → 1 ATF draining
-- Follow the instructions in the display.
Danger of eye injury.
- Wear protective eyewear.
-- Remove the plug -arrow- on the drain opening or open the plugs and let the ATF drain.
Risk of damaging the transmission.
- Do not start the engine when there is no ATF in the transmission.
Follow the disposal requirements.
-- Tighten the ATF drain plug.
-- Clean the subframe crossbrace and remove any remaining ATF.
Filling
Risk of damaging the transmission.
- Only use the listed replacement ATF for the dual-clutch transmission 0CJ, 0CK, 0HL.
- Using other fluids can cause malfunctions or transmission failure.
- Note the allocation. Refer to the Parts Information.
- The :VAS6617 must be clean and ATF must not be mixed with another fluid! Rinse the hand pump with ATF if necessary.
Danger of eye injury.
- Wear protective eyewear.
-- Remove the plug -arrow- on the inspection and fill hole or open the plugs all the way.
-- Guide the :VAS6617 with :VAS6617/1 and :VAS6617/12 in the hole.
Risk of damaging the transmission by mixing ATF and transmission fluid (MTF) through the same bleeder.
- The ATF filling quantity of 3.5 liters must not be exceeded.
-- Fill with transmission with 3.5 liters of ATF using the hand pump.
-- Connect the Vehicle Diagnostic Tester with the vehicle and start the Diagnostic mode.
- Select vehicle test
- 0002-Transmission electronics, Guided Functions
- 0002-ATF level, checking → 2 ATF filling
-- Start the selected program and follow the instructions in the display of the Vehicle Diagnostic Tester.
-- Tighten the plug -arrow- on the inspection and fill hole or close the plugs all the way.
Tightening Specifications
- Plug: Refer to -item ) Plugs.
- Refer to OVERVIEW - SUBFRAME .
- Refer to OVERVIEW - NOISE INSULATION .