Steering Angle Sensor -G85- BASIC SETTING
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Steering Wheel Scales :VAS6458A
Procedure
This basic setting should be selected after the following actions:
- Settings to the suspension were changed.
- The Steering Column Electronics Control Module -J527- was replaced.
- The Active Steering Control Module -J792- was replaced,
- The steering column was replaced.
-- After performing the respective procedures, select the "Calibration" program for the Steering Angle Sensor -G85-. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- Equipment version with dynamic steering: performing basic setup of the dynamic steering. Refer to DYNAMIC STEERING BASIC SETTING .