Rear Axle Steering Gear, Moving Into Zero Position

Special tools and workshop equipment required 

• Vehicle Diagnostic Tester

Procedure 

An angle up to 4.8° is still possible when the vehicle is stationary. Therefore, the rear axle steering gear must be brought into the zero position before a vehicle alignment or before adjusting any driver assistance systems.

• This is the only way to ensure that the rear axle steering is in the straight-ahead position.

-- Select the "Rear Axle Steering Gear, Moving into Zero Position" program. Refer to DIAGNOSTIC ENTRIES .

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.