Seat Position Sensor, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
-- Hook the bracket -2- into the upper seat rail and clip it in.
-- Slide the seat position sensor -4- on the bracket and position at a distance -a- = 4.0 mm to the lower seat rail -1-.
-- To do this, position the Gauge - Gap Adjustment :3371 / 4 mm or Gauge - Eos Roof :VAS 6448 / 4 mm between the seat position sensor and the lower seat rail and tighten the screw -3-.
Requirement
- Check the seat position sensor with the Vehicle Diagnostic Tester.