Outer Rear Three-Point Seat Belt, Removing And Installing: Removing

-- Move the front seats all the way forward.

-- Press the seat belt guide trim -1- out of the retainers -2- and -3- using the Trim Removal Wedge :3409  and remove the trim.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the side cushion. Refer to OVERVIEW - COVER AND CUSHION .

-- Remove the luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING, VEHICLES WITHOUT HIGH-VOLTAGE SYSTEM / LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING, VEHICLES WITH HIGH-VOLTAGE SYSTEM .

-- Remove the D-pillar trim panel and bracket. Refer to D-Pillar Trim Panel, Removing and Installing .

-- Remove the outer rear belt end fitting. Refer to OUTER REAR BELT END FITTING, REMOVING AND INSTALLING  .

-- Disconnect the connector -4-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

-- Unclip the wiring harness and push to the side.

-- Remove the insulation mat.

-- Loosen the bolt -1- approximately seven turns.

-- Push the three-point seat belt -3- toward the rear -arrow-, disengage it from the mount and remove it.