Outer Rear Three-Point Seat Belt, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
-- Insert the three-point seat belt -1- with the anti-twist mechanism and bolt -2- into the mount -3-.
-- Push the three-point seat belt -1- all the way forward -arrow- and tighten the bolt -2- at the same time.
Requirement
- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.
- Make sure the connectors are pushed in all the way and that they engage audibly.
- If equipped, after replacing the Left Rear Seat Belt Tensioner Control Module -J1097- /Right Rear Seat Belt Tensioner Control Module -J1098-, the control module must be adapted using the Vehicle Diagnostic Tester.
-- If the battery was disconnected, perform the required steps after connecting the battery. Refer to BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITHOUT ALTERNATIVE DRIVE SYSTEM, (0K0) / BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH HIGH-VOLTAGE SYSTEM, (0K3) / BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4) .