Front Belt End Fitting, Removing And Installing: Removing
-- Move the front seat all the way to the front and into the highest position.
-- Remove the B-pillar lower trim panel. Refer to B-Pillar Lower Trim Panel, Removing and Installing .
Belt end fitting without seat belt tensioner
-- Push the carpet in the threaded connection area to the side.
-- Remove the bolt -1-.
-- Remove the bolt with the belt anchor -2-.
Continuation for all vehicles
Belt end fitting with seat belt tensioner
-- Push the carpet in the belt end fitting -3- area to the side.
-- Remove the bolt -1- and then remove the belt relay -2-.
-- Disengage the belt end fitting -3- from the bracket.
-- Open the cover -2- for the belt anchor -1- on the catches -arrow-, open and push aside.
-- Push together the catches on the clamp with pliers -A arrows-.
-- At the same time push the anchoring pins -2- together with the clamp -3- to release in the -direction of arrow B-.
-- Disengage the anchoring pin -2- from the clamp -3- in the belt end fitting -1-.
Continuation for all vehicles