Pressure Hose Sensor For Front Pedestrian Protection G579, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
-- Engage the pedestrian protection crash sensor -1- into the molded foam part -3-.
Requirement
- Do not kink or turn the pressure hose -2-.
- The pressure hose -2- must be inserted without any tension.
-- Install the molded foam part with the pedestrian protection crash sensor. Refer to Front Bumper .
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Attach the connector -1- to the crash sensor until it clicks into place -arrow-.
-- Push in the connector lock -2- to secure the connector.
Requirement
- Make sure the wires are not pinched.
Pyrotechnical components can deploy unexpectedly.
A risk of injury is possible.
- Keep as far away as possible from the pyrotechnic component when switching the ignition on.
-- If the battery was disconnected, perform the required steps after connecting the battery. Refer to BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITHOUT ALTERNATIVE DRIVE SYSTEM, (0K0) / BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH HIGH-VOLTAGE SYSTEM, (0K3) / BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4) .