Front Passenger Airbag Unit With Igniter, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
Requirement
- Replace the connector for the Front Passenger Airbag Release Valve Igniter -N491- after an airbag has deployed. Refer to WIRING HARNESSES AND CONNECTORS, REPAIRING .
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Connect the connector -1- to the airbag igniter -arrow A-.
-- Press in the connector lock -2- -arrow B-. While doing this, the connector is pushed into the airbag igniter and locks into place.
Requirement
- Make sure the wires are not pinched.
Pyrotechnical components can deploy unexpectedly.
A risk of injury is possible.
- Keep as far away as possible from the pyrotechnic component when switching the ignition on.
-- If the battery was disconnected, perform the required steps after connecting the battery. Refer to BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITHOUT ALTERNATIVE DRIVE SYSTEM, (0K0) / BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH HIGH-VOLTAGE SYSTEM, (0K3) / BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4) .