Airbag Unit With Igniter, Removing And Installing: Removing

Requirement

• To enable turning the steering wheel into the removal position on a vehicle with Electronic Steering Column Lock Control Module -J764- the ignition remains switched on for the following steps.

-- Move the steering wheel as far to the rear and down as possible. Use the full steering column adjustment range for this.

-- Move the steering wheel -1- out of the straight-ahead position by turning it clockwise 90° -arrow A-, so that the opening -arrow B- on the rear side of the steering wheel faces directly upward (approximately 12 o'clock position).

Courtesy of AUDI OF AMERICA, LLC

-- Guide a Phillips head screwdriver -1- or Torx screwdriver T15 (approximately 80 mm long) in the opening until it stops.

Courtesy of AUDI OF AMERICA, LLC

-- Release the locking bracket for the airbag by pulling the screwdriver upward with force -arrow-.

-- The airbag catch -arrow B- is loosened from the steering wheel by pressing down the locking bracket -1-. (Shown with the airbag removed).

Courtesy of AUDI OF AMERICA, LLC

Tip

Never remove the airbag unit by pulling forcefully.

-- If the airbag unit cannot be detached, push it back into the steering wheel and repeat the procedure.

-- Move the steering wheel -1- back counter-clockwise 180° -arrow A-, so that the opening -arrow B- on the rear side of the steering wheel faces directly upward (approximately in the 12 o'clock position).

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the second catch -arrow A- on the steering wheel.

Courtesy of AUDI OF AMERICA, LLC

Requirement

• The airbag unit remains in the steering wheel.

-- Bring the steering wheel back into the center (wheels are straight).

-- Remove the airbag -1- from the steering wheel slightly.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

-- Remove the connector lock -4- and disconnect the connector -3-.

Requirement

• Store the airbag with the cushion facing upward.