Airbag Unit With Igniter, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
Requirement
- Make sure the connectors are pushed in all the way and that they engage audibly.
- Make sure the wires are not pinched.
-- Connect the connector -1- and push in to attach to the pockets on the steering wheel.
-- Connect the connector -2- all the way onto the Steering Column Electronics Control Module -J527- -arrow A-.
-- Push in the connector lock -3- -arrow B-, which will lock the connector.
-- Position the driver side airbag in the steering wheel and press on until it audibly engages.
Pyrotechnical components can deploy unexpectedly.
A risk of injury is possible.
- Keep as far away as possible from the pyrotechnic component when switching the ignition on.
-- If the battery was disconnected, perform the required steps after connecting the battery. Refer to BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITHOUT ALTERNATIVE DRIVE SYSTEM, (0K0) / BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH HIGH-VOLTAGE SYSTEM, (0K3) / BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4) .