ATF, Filling
WARNING: This page is about a different car, the 2024 Audi S7, 2024 Audi RS 7 Sportback, 2023 Audi S7, and 2023 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- If no ATF leaks out of the ATF check and fill hole -arrow B- before the ATF reaches 40 °C (104 °F) :
- At 45 °C (113 °F) the ATF inspection plug must be installed again. Let the transmission cool down and check again.
-- Install the :VAS6262/5 into the ATF check and fill hole -arrow-.
-- Fill with ATF using the adapter until the ATF starts to leak out of the check and fill hole.
Tip:
Too little or too much ATF will impair transmission function.
-- Tighten the new plug -arrow B-. The ATF level test is now completed.
Tightening Specifications
- Refer to Drain and Plug
- Refer to OVERVIEW - SUBFRAME .
- Refer to OVERVIEW - NOISE INSULATION .