ATF Lines, Removing And Installing: Notes
WARNING: This page is about a different car, the 2024 Audi S7, 2024 Audi RS 7 Sportback, 2023 Audi S7, and 2023 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit:SMN372500
- Hose diameter approximately 18 mm
- Compressed air gun, commercially available
- Protective Eyewear
Removing and Installing
- General repair instructions. Refer to GENERAL REPAIR INFORMATION .
- Guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Seal the open lines and connections with clean plugs from the :VAS6122 .
- Replace the O-rings after removal.
- Check the ATF level after removing and Installing ATF lines. Refer to ATF LEVEL, CHECKING .
-- Remove the noise insulation. Refer to approrpriate Service Information .
-- Disconnect the ATF lines -arrows-. Refer to Figure.
-- Remove the bolts -arrows- and remove the ATF lines from the transmission. (different versions)
CAUTION:
Risk of damaging the transmission due to faulty ATF cooling system.
- Remove the plugs on the ATF lines and on the transmission.