Cam Actuator, Removing And Installing
Cylinder Bank 1 (Right) Cam Actuator, Removing
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
Cylinder Bank 2 (Left) Cam Actuator, Removing
-- Remove the Engine Control Module -J623-. Refer to Engine Control Module -J623-, REMOVING AND INSTALLING .
-- Remove the connectors -3 and 4- from the bracket and free up the wire.
-- Free up the wiring harness -1-.
-- Remove the bolts -arrows- and then remove the bracket -2- for the engine/motor control module.
Continuation for Both Sides:
All additional procedures are described. Refer to CAMSHAFT, REMOVING AND INSTALLING .
Installing
Additional procedures:
-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
Tightening Specifications
- Refer to OVERVIEW - ENGINE CONTROL MODULE