ADDITIONAL WORK AFTER REPLACING Differential Lock Control Module -J187-

• Only perform the additional work only if the Differential Lock Control Module -J187- was replaced.

-- Connect the Vehicle Diagnostic Tester and turn on the ignition.

-- Select the function 32 - Replacing Control Module  on the Vehicle Diagnostic Tester under Guided Functions  in the directory 32- Locking Electronics  .

• Follow all the instructions given by the Vehicle Diagnostic Tester exactly.

The installed rear final drive is "adapted" to the Differential Lock Control Module -J187- using the Vehicle Diagnostic Tester.

• A system check will take place when the 32 - Control Module, Replacing  function is complete. If malfunctions appear, then use"Guided Fault Finding"  to correct them.