Input Shaft Seal, Replacing, 0DG: Notes

Special tools and workshop equipment required 

• Press Piece - Multiple Use :VW 431 

  Courtesy of AUDI OF AMERICA, LLC

• Puller - Unit Injector :T10055 
  Fig 1: Identifying Puller T10055

  Courtesy of AUDI OF AMERICA, LLC
• -2- Puller - Unit Injector - Adapter 2 :T10055/2 
• Thrust washer from Seal Installer - Rear Crankshaft :T10134 
  Fig 2: Identifying Seal Installer - Rear Crankshaft

  Courtesy of AUDI OF AMERICA, LLC
• Seal Installer - Hollow Shaft :T10380 
  Fig 3: Identifying Thrust Piece - T10380-

  Courtesy of AUDI OF AMERICA, LLC
• Seal Installer - Shaft Seal :T10432 
  Fig 4: Identifying Assembly Tool T10432

  Courtesy of AUDI OF AMERICA, LLC
• -1- Two-Arm Puller :VAS251001 
  Fig 5: Identifying Special Tools - Kukko 20/10 Puller Set

  Courtesy of AUDI OF AMERICA, LLC
• Inductive Heater :VAS 6414 
  Fig 6: Identifying Inductive Heater VAS 6414

  Courtesy of AUDI OF AMERICA, LLC
• or
• Commercially Available Hotplate with Digital Thermometer :VAS 6519 
  Fig 7: Identifying Digital Thermometer VAS 6519

  Courtesy of AUDI OF AMERICA, LLC
• Used Oil Collection and Extraction Unit :SMN372500 
  Fig 8: Identifying Used Oil Collection And Extraction Unit

  Courtesy of AUDI OF AMERICA, LLC
• Sealing Grease :G 052 128 A1