Component Location Overview - Heat Shield
- Heat Shield
- Tightening Specifications:
- Spring nuts: 2 Nm
- For the rear muffler
- Tightening Specifications:
- Heat Shield
- Tightening Specifications:
- Spring nuts: 2 Nm
- Rear floor
- Tightening Specifications:
- Heat Shield
- For the driveshaft
- Removing and Installing. Refer to DRIVESHAFT HEAT SHIELD, REMOVING AND INSTALLING .
- Heat Shield
- For the tunnel rear
- Removing and Installing. Refer to HEAT SHIELD FOR REAR TUNNEL, REMOVING AND INSTALLING .
- Heat Shield
- Tightening Specifications:
- Spring nuts: 2 Nm
- Lock Washer
- For the tunnel center
- Removing and Installing. Refer to CENTER TUNNEL HEAT SHIELD, REMOVING AND INSTALLING .
- Tightening Specifications:
- Heat Shield
- For right front tunnel
- Removing and Installing. Refer to HEAT SHIELD FOR FRONT TUNNEL, REMOVING AND INSTALLING .
- Lock Washer
- Heat Shield
- Tightening Specifications:
- Nut: 9 Nm
- Clip
- For right front longitudinal member
- Tightening Specifications:
- Heat Shield
- For the plenum chamber bulkhead
- Removing and Installing. Refer to PLENUM CHAMBER BULKHEAD HEAT SHIELD, REMOVING AND INSTALLING .
- Lock Washer
- Heat Shield
- For left front longitudinal member
- Clip
- For left front longitudinal member
- Heat Shield
- For left front tunnel
- Removing and Installing. Refer to HEAT SHIELD FOR FRONT TUNNEL, REMOVING AND INSTALLING .
- Lock Washer
- Heat Shield
- Tightening Specifications:
- Spring nuts: 2 Nm
- Tightening Specifications: