Electric Drive Control Module On Rear Axle J1235/J1236, Removing And Installing, S Model: Installing
Install in reverse order of removal and note the following:
Condition
- Replace the sealing element.
- Replace the coolant connection with O-rings.
- Replace the cover for the high-voltage cables.
- Always replace a removed clip for noise insulation on the motor.
- Used coolant cannot be used again.
-- Coat the O-rings for the coolant connections with coolant and insert them into the motor until they stop.
-- Connect the sealing element for installation to the electric drive control module.
-- Attach the respective electric drive control module onto the motor and tighten the bolts.
-- Tighten the bolts -arrows-.
-- Install the new high-voltage cables cap and tighten the bolts -1- through -6-.
If the Electric Drive Control Module on Rear Axle Electric Drive Control Module on Rear Axle - J1235- /Electric Drive Control Module 2 on Rear Axle - J1236- was replaced, the test plan for replacing the control module must be completed.
-- Complete the "Control module, replacing" function with the Vehicle Diagnostic Tester . Refer to Diagnostic Entries .
Continuation