Fresh Air Blower -V2- WITH Fresh Air Blower Control Module -J126-, REMOVING AND INSTALLING: Removing
-- Switch of the function "parking heater" (deactivate). Refer to the Owner's Manual.
-- Position the front passenger seat as far back as possible.
-- Switch the ignition off.
-- Remove the footwell vent on the front passenger side. Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
-- Remove the air duct for glove compartment cooling. Refer to AIR GUIDE FOR GLOVE COMPARTMENT COOLING, REMOVING AND INSTALLING .
-- Release the connector -A- and remove from the Fresh Air Blower -V2- (with the Fresh Air Blower Control Module -J126-) -C-.
-- Remove the insulation -B-.
-- Remove the bolts -A-.
There is a risk of burns from the hot radiating surface of the fresh air blower control module.
It is possible to burn hands.
- Wear safety gloves.
Risk of damaging the fresh air blower if operated incorrectly.
Imbalance and problems during operation is possible.
- Avoid using force on the fan wheel.
- Never move the balancing weight on the fan wheel.
- Do not place the fresh air blower on the fan wheel.
-- Remove the Fresh Air Blower -V2- (with the Fresh Air Blower Control Module -J126-) -B- carefully from air intake housing -C-.