Right Side Vent Motor -V300-, REMOVING AND INSTALLING, PR NUMBER 9AQ: Removing
-- Switch of the function "parking heater" (deactivate). Refer to the Owner's Manual.
-- Move the right front seat all the way to the rear.
-- Switch the ignition off.
-- Remove the air duct for glove compartment cooling. Refer to AIR GUIDE FOR GLOVE COMPARTMENT COOLING, REMOVING AND INSTALLING .
-- Remove the footwell vent on the front passenger side. Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
-- Label the connector -C- and the actuator -B- (to avoid a mix up in case several connectors are disconnected at the same time).
-- Remove the bolts -A-.
-- Remove the actuator -B- from the door shaft -D-.
-- Disconnect the connector -C-.