Cover And Cushion, Removing And Installing, Rear Bench Seat: Notes

Special tools and workshop equipment required 

• Pry Lever:80-200 
  Fig 1: Identifying Pry Lever

  Courtesy of AUDI OF AMERICA, LLC

Removing

-- Remove the rear bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .

-- Place the rear seat bench on a clean surface.

-- Pry out the molding as well as the clamping strips -arrows- for the cover using a flat-head screwdriver and remove it by hand along the seat frame all around the molded part.

Courtesy of AUDI OF AMERICA, LLC

-- Equipped on some models: free up the wire if necessary and disconnect the connectors.

-- Remove the cover and cushion -1- from the seat frame.