Cover And Cushion, Separating, Rear Bench Seat: Removing
-- Remove the rear bench seat. Refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING .
-- Place the rear seat bench on a clean surface.
-- Equipped on some models: free up the connector from the bracket -1-.
-- Disengage and remove the bracket on the seat cushion in direction of -arrow-.
-- Repeat the procedure on the opposite side.
-- Pry out and disengage the molding -1- of the cover all around the seat cushion -3- using a flat-head screwdriver.
-- Guide out the cover bracket -2- through the slot in the cushion.
-- Pull the cover -2- as far off of the cushion -1- as possible and cut the upholstery clips -arrow- using pliers.
-- Cut the remaining upholstery clips and remove the cover from the cushion.