Drive Plate, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi A8 Quattro, 2023 Audi A8 Quattro, and 2022 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

If the drive plate was removed or replaced, the sensor wheel function must be checked before installation. Refer to SENSOR WHEEL, CHECKING .
Replace bolts that were tightened with an additional turn after removing them.

-- Pay attention to the alignment pin when installing the drive plate.

-- Reposition the Counterhold - Flywheel: 10 - 201 to tighten the bolts.

After removing and installing or replacing perform the listed adaptation in the 0001 - Engine Electronics Functions "0001 - Steps after replacing components" using the.