Engine Speed Sensor -G28-, REMOVING AND INSTALLING
WARNING: This page is about a different car, the 2024 Audi A8 Quattro, 2023 Audi A8 Quattro, and 2022 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Disconnect the connector -2-.
-- Remove the bolt -1- and the Engine Speed Sensor -G28-.
Installing
Install in the reverse order of removal while noting the following:
- Replace the O-rings after removing them.
Tightening Specifications
- Refer to OVERVIEW - IGNITION SYSTEM
- Refer to OVERVIEW - NOISE INSULATION .