Vibration Damper, Removing And Installing, 2.9L Engine: Installing

WARNING: This page is about a different car, the 2024 Audi A8 Quattro, 2023 Audi A8 Quattro, and 2022 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Replace bolts that were tightened with an additional turn after removing them.

-- Position the vibration damper -1- on the crankshaft -2- and secure it with a new bolt. Pay attention to the alignment sleeve -arrow- at the same time.

-- Place the Adapter: T40330/4 with Counterholder: T40330/1 on the vibration damper and secure using the bolt -arrow- (23 Nm); to do so, place the Spacer Sleeve: T40330/7 underneath.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the vibration damper bolt -1-.

-- Remove the bolt -arrow- and remove the counterholder.

-- Install the ribbed belt tensioner for the A/C compressor. Refer to RIBBED BELT TENSIONER FOR A/C COMPRESSOR, REMOVING AND INSTALLING, 2.9L ENGINE .

-- Installing the generator ribbed belt. Refer to RIBBED BELT FOR GENERATOR, REMOVING AND INSTALLING, 2.9L ENGINE .

There are different procedures depending on the model. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .