Overview - Oil Pan/Oil Pump

Fig 1: Exploded View Of Oil Pan/Oil Pump

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Replace after removing
- Tightening Specifications and Sequence. Refer to Fig 2.
Oil Pan Lower Section
- Removing and Installing. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
Intake Tube
- For the oil pump
Bolt
- 9 Nm
Bolt
- 9 Nm
Chain Guard
Chain Sprocket
- For the oil pump
Bolt
- Replace after removing
- 20 Nm +90°
Seal
- Replace after removing
Bolt
- Replace after removing
- Tightening Specifications and Sequence. Refer to Fig 3.
Oil Pan Upper Section
- Removing and Installing. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
Alignment Pin
- In cylinder block
Bolt
- 9 Nm
Oil Tray
Alignment Pin
- In cylinder block
Alignment Sleeve
Oil Pump
- Removing and Installing. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Do not disassemble
Bolt
- 9 Nm
O-Ring
- Replace after removing
Bolt
- 9 Nm
Seal
- Replace after removing
Fluid Drain Plug
- Oil the threads
- 30 Nm
Bolt
- 9 Nm
Oil Level Thermal Sensor -G266-
- Removing and Installing. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
Seal
- Replace after removing

Oil Pan Lower Section - Tightening Specifications and Sequence

Fig 2: Oil Pan Lower Section - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -1 to 18- as shown in steps.

Step	Tightening Specification/Additional Turn
1.	Install all the way by hand
2.	9 Nm

Oil Pan Upper Section - Tightening Specifications and Sequence

Fig 3: Oil Pan Upper Section - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

These multiple tightenings to 9 Nm take into account the shrinkage of the components.

-- Tighten the bolts -1 to 21- in steps as shown: