Bonded Rubber Bushing, Removing And Installing

Special tools and workshop equipment required 

• Hydraulic Press - Ball Joint Assembly Tools: T10254 
  Fig 1: Hydraulic Press - Ball Joint Assembly Tools T10254

  Courtesy of AUDI OF AMERICA, LLC
• Assembly Tool: T40342 

  Courtesy of AUDI OF AMERICA, LLC

• Hydraulic Press: VAS 6178 
  Fig 2: Identifying Hydraulic Press VAS6178

  Courtesy of AUDI OF AMERICA, LLC
• Pneumatic/Hydraulic Foot Pump: VAS 6179 
  Fig 3: Identifying Pneumatic/Hydraulic Foot Pump VAS6179

  Courtesy of AUDI OF AMERICA, LLC
• Installation lubricant. Refer to the Electronic Parts Information (ETKA).

Bonded Rubber Bushing, Removing

Courtesy of AUDI OF AMERICA, LLC

Bonded Rubber Bushing Installation Position

Fig 4: Bonded Rubber Bushing Installation Position

Courtesy of AUDI OF AMERICA, LLC

• The trapezoid-shaped hole in the bonded rubber bushing -arrow A- faces upward.
• The rubber-coated side of the metal insert -arrow B- faces toward the driveshaft.

Bonded Rubber Bushing -A-, Installing

Courtesy of AUDI OF AMERICA, LLC

• Pay attention to the installation position of the bonded rubber bushing. Refer to Fig 4.
• The beveled side of the Assembly Tool - Guide Sleeve: T40342/1  -arrow- faces inward toward the final drive.
• The beveled side of the Pressure Plate: T40342/4  faces toward the Hydraulic Press: VAS 6178  .

-- Coat the outer edge of the bonded rubber bushing -A- with installation lubricant.

-- Press in the bonded rubber bushing all the way to the Pressure Plate: T40342/4  .