Brake Fluid Reservoir, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

• Coat the plugs on the brake fluid reservoir with brake fluid.

-- Insert the brake fluid reservoir into the plugs in the brake master cylinder.

-- Tighten the bolt -arrow- for the brake fluid reservoir.

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -2- for the Brake Fluid Level Warning Switch -F34-.

-- Fill the brake fluid reservoir up to the "MIN" mark.

Fig 1: Brake Fluid Reservoir

Courtesy of AUDI OF AMERICA, LLC

-- Remove all cloths from the vehicle that were previously placed down.

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM, BLEEDING .

-- Install the refrigerant lines in the plenum chamber. Refer to Refrigerant Circuit .

-- Install the tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .