Overview - Driver Side Airbag, Round Version

Fig 1: Exploded View Of Driver Side Airbag, Round Version

Courtesy of AUDI

1. Wiring Harness
   • For the Driver Airbag Igniter -N95- and Driver Airbag Release Valve Igniter -N490-
   • Refer to CONNECTOR ON AIRBAG, REMOVING AND INSTALLING 
2. Steering Wheel
   • Refer to Overview - Steering Wheel .
3. Steering Column Electronics Control Module -J527-
   • Refer to OVERVIEW - STEERING COLUMN SWITCH MODULE .
4. Bolt
   • Tightening specification. Refer to OVERVIEW - STEERING WHEEL .
5. Driver Side Airbag
   • with
     • Driver Airbag Igniter -N95-
     • Driver Airbag Release Valve Igniter -N490-
   • Use a T25 TORX screwdriver, approximately 100 mm long
   • Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING