Right Flange Shaft, Removing And Installing: Notes

WARNING: This page is about a different car, the 2024 Audi A5 Quattro and 2023 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Circlip Pliers:VAS 5503A

Courtesy of AUDI OF AMERICA, LLC
Used Oil Collection and Extraction Unit:SMN372500

Fig 1: Identifying Used Oil Collection And Extraction Unit
Courtesy of AUDI OF AMERICA, LLC
Puller - Flanged Shaft:T10037

Fig 2: Identifying Flanged Shaft
Courtesy of AUDI OF AMERICA, LLC
Adapter:T10037/2

Courtesy of AUDI OF AMERICA, LLC
Sealing Grease. Refer to the appropriate Electronic Parts Information.

Removing

The transmission is installed.

-- Remove the right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Remove the right drive axle heat shield. Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .

-- Place the Used Oil Collection and Extraction Unit:SMN372500 under the transmission.

-- Remove right flange shaft by fastening Puller - Flanged Shaft:T10037 to transmission housing -arrow-.

Fig 3: Identifying Right Flange Shaft By Fastening T10037

Courtesy of AUDI OF AMERICA, LLC

-- Use the Adapter:T10037/2 , if necessary.