Differential, Removing And Installing: Notes

WARNING: This page is about a different car, the 2024 Audi A5 Quattro and 2023 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Gearbox Support:T40173A

Fig 1: Gearbox Support T140173
Courtesy of AUDI OF AMERICA, LLC
Engine and Gearbox Jack:VAS 6931

Fig 2: Engine and Gearbox Jack VAS6931 or VAG1383A
Courtesy of AUDI OF AMERICA, LLC
Puller - Flanged Shaft:T10037

Fig 3: Identifying Flanged Shaft
Courtesy of AUDI OF AMERICA, LLC
Shop Crane - Drip Tray:VAS 6208

Fig 4: Identifying Drip Tray
Courtesy of AUDI OF AMERICA, LLC

Before performing assembly work on the differential, drain the transmission fluid, secure the transmission on the assembly stand, and remove the clutch module with the right flange shaft. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .

Conditions

Courtesy of AUDI OF AMERICA, LLC

Gearbox Support:T40173 with yellow chrome plated mount and joint housing -B- or applicable CE identification -A-.