Solenoid Valves And Pressure Regulating Valves In Valve Body, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi A5 Quattro and 2023 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Check before the repair, if the necessary replacement parts are available. Refer to the appropriate Electronic Parts Information.
Do not remove the clutch piston valve -arrow- it remains in the valve body.
Due to the exact positioning of components, reinstallation is not possible, since the valve body would be damaged.
-- Remove the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .
-- Remove the Transmission Control Module -J217-. Refer to Transmission Control Module -J217-, REMOVING AND INSTALLING .
-- Remove bolts -arrows- and remove the contact element.
- Hold the Solenoid Valve 5 -N92- -1- when removing the mounting rail.
- The clutch cooling valve -2- and the spring -3- must remain in the valve body.
-- Remove the bolts -arrows- and remove the mounting rail.
-- Remove the valves if necessary carefully pry out as shown.