Parking Lock Solenoid -N486- /Drive Position Sensor -G676-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2024 Audi A5 Quattro and 2023 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Push the Drive Position Sensor -G676- onto the parking lock shaft; while doing so, pay attention to the different notches -arrows- and hand-tighten the bolt -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Check if the splines on the Drive Position Sensor -G676- are flush with the splines on the parking lock shaft.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolt -arrow- to the tightening specification.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When installing the Parking Lock Solenoid -N486-, pay attention that the alignment pin is seated correctly.

Courtesy of AUDI OF AMERICA, LLC

-- Install both bolts -arrows- with lightened spring force and tighten to the tightening specification.

Courtesy of AUDI OF AMERICA, LLC

-- To do this using a pin punch shaft turn the parking lock approximately 3° against the spring force.

NOTE:

Pay attention to the correct installation position!

Courtesy of AUDI OF AMERICA, LLC

The lever from the parking lock is flush to the shaft splines -arrow-.

If necessary align with less spring force!

NOTE:

If necessary the spring pin can also be pushed in using pliers.

Never drive in the tensioning pin because the shaft will be damaged.

-- Press the tensioning pin -1- in using the Removal Tool :T40437 -A- and :T40437/1 -B-.

Courtesy of AUDI OF AMERICA, LLC