Camshaft Timing Chain, Removing From Camshafts, Cylinder Bank 2 (Left): Notes

For the following procedure the camshaft timing chain remains on the engine.

Special tools and workshop equipment required 

• Electronic Torque Wrench 3-60Nm:VAS6583 
  Fig 1: Electronic Torque Wrench 3-60Nm

  Courtesy of AUDI OF AMERICA, LLC
• Locking Pins:T03006 
  Fig 2: Locking Pins

  Courtesy of AUDI OF AMERICA, LLC
• Crankshaft Locking Pin:T40069  (with the engine removed)
  Fig 3: Crankshaft Locking Pin T40069

  Courtesy of AUDI OF AMERICA, LLC
• Wrench - 21mm:T40263 
  Fig 4: Identifying Wrench - 21mm

  Courtesy of AUDI OF AMERICA, LLC
• Camshaft Lock:T40264/3 
  Fig 5: Camshaft Lock

  Courtesy of AUDI OF AMERICA, LLC
• Adapter:T40314 
  Fig 6: Adapter T40314

  Courtesy of AUDI OF AMERICA, LLC
• Camshaft Positioning Tool:T40331  , not illustrated
• Socket E24:T90000  , not illustrated
• Counterholder:T90001  , not illustrated
• Counterholder:T90002  , not illustrated
• Socket :VAS261001  , not illustrated
• Hazet 6423C (commercially available), not illustrated

Camshaft Locking Device:T40331  , Preparing

Courtesy of AUDI OF AMERICA, LLC

• The lettering "B" on the Camshaft Positioning Tool:T40331/1  points forward.
• The Camshaft Positioning Tool:T40331/5  and :T40331/6  as well as the washers on the bolts :T40331/9  must be positioned using the alignment pins -arrows-.

-- Tighten the bolts hand-tight.