Vacuum Pump, Removing And Installing, 2.0L TFSI Engine: Installing

Install in the reverse order of removal while noting the following:

• Replace the seal after removal.
• Check the vacuum lines for damage before assembling and replace if necessary.
• Secure all hose connections with hose clamps that match the ones used in series production. Refer to the appropriate Electronic Parts Information.

-- Turn the vacuum pump yoke -1- so it engages in the groove on the camshaft when positioning the vacuum pump -arrows-.

Fig 1: Locating Bolts And Vacuum Pump

Courtesy of AUDI

-- Install the vacuum hose with the hose clamp -1- connected.

Courtesy of AUDI

-- Tighten the bolts -arrows-.

-- Install the high pressure pump. Refer to the appropriate Service Information .