Vacuum Pump, Removing And Installing, 2.0L TDI EVO Engine: Installing
Install in the reverse order of removal while noting the following:
- Replace the seal after removal.
- Check the vacuum lines for damage before assembling and replace if necessary.
-- Position the vacuum pump driver -1- so it engages in the symmetrical groove on the camshaft when positioning -arrows-.
-- Install the air duct pipe. Refer to OVERVIEW - CHARGE AIR SYSTEM (2.0L) , OVERVIEW - CHARGE AIR SYSTEM (2.9L) .
-- Install the plenum chamber bulkhead. Refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING (2.0L) , ENGINE COVER (2.9L) .