Transmission, Transporting
Special tools and workshop equipment required
Risk of damaging the transmission by mixing ATF and transmission fluid (MTF) through the same bleeder.
- The transmission filled with ATF and (MTF) transmission fluid must be tilted a maximum of 15° in lateral and longitudinal direction.
- If more of an incline is needed, then the ATF and MTF transmission fluids must be drained.
- Drain the ATF. Refer to ATF, DRAINING AND FILLING .
- Drain the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .
Maximum Transmission Tilt
Transmission without electric drive motor
-- Secure the transmission -1- on the Hook and Support Tool:T40406 .
- -4- = Hook and Support Tool:T40406/1 for transmission without electric drive motor.
- Depending on the transmission fluid level the shackle in the rail with holes -arrow- can vary to reach the correct adjustment.
-- Lift and transport the transmission with the Shop Crane:VAS 6100 -3-.
Transmission with electric drive motor
-- Secure the transmission -1- on the Hook and Support Tool:T40406 .
- -4- = Hook and Support Tool:T40406/2 for transmission with electric drive motor.
- Depending on the transmission fluid level the shackle in the rail with holes -arrow- can vary to reach the correct adjustment.
-- Lift and transport the transmission with the Shop Crane:VAS 6100 -3-.
Continuation for all vehicles