Parking Lock Solenoid -N486- /Drive Position Sensor -G676-, REMOVING AND INSTALLING: Installing

Install in the reverse order of removal while noting the following:

-- Push the Drive Position Sensor -G676- onto the parking lock shaft; while doing so, pay attention to the different notches -arrows- and hand-tighten the bolt -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Check if the splines on the Drive Position Sensor -G676- are flush with the splines on the parking lock shaft.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolt -arrow- to the tightening specification.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When installing the Parking Lock Solenoid -N486-, pay attention that the alignment pin is seated correctly.

Courtesy of AUDI OF AMERICA, LLC

-- Install both bolts -arrows- with lightened spring force and tighten to the tightening specification.

Courtesy of AUDI OF AMERICA, LLC

-- To do this using a pin punch shaft turn the parking lock approximately 3° against the spring force.

NOTE:

Pay attention to the correct installation position!

Courtesy of AUDI OF AMERICA, LLC

The lever from the parking lock is flush to the shaft splines -arrow-.

If necessary align with less spring force!

-- Press the tensioning pin -1- in using the Removal Tool :T40437  -A- and :T40437/1  -B-.

Courtesy of AUDI OF AMERICA, LLC