Parking Lock Shaft Seal, Replacing

Special tools and workshop equipment required

Procedure

-- Remove the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and push the coolant pipe for the transmission to the side. (different versions)

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -items 1 and 2-.

-- Remove the bolts -arrows- and move the parking lock emergency release cable -1- to the side. (different versions)

Courtesy of AUDI OF AMERICA, LLC

-- Press the tensioning pin -1- out using the Removal Tool:T40437 -A-.

Courtesy of AUDI OF AMERICA, LLC

Depending on the transmission, the parking lock lever may be installed in various positions. See the illustrations above and below.

-- Remove the bolt -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -3-.

-- Remove the bolts -arrows- and the parking lock cover -1-.

-- Remove the seal with the Thrust Piece:T10040/3 .

Courtesy of AUDI OF AMERICA, LLC

-- Press in the new seal with the Thrust Piece:T10040/3 to the installation dimension 0.5 mm.

Tightening Specifications