ATF Cooler, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
NOTE:
Replace the ATF line with seals after removing.
Clean the ATF cooler before installing.
CAUTION:
ATF cooler leak!
- Pay attention to the ATF pipe installation position.
- The side of the pipe with three seals faces the ATF cooler.
-- Install the bolts all the way in by hand and tighten in the previously specified tightening sequence.
-- If the bolts are difficult to reach, tighten them using the Torx Screwdriver Bit - T30:VAS6959 .
-- Bleed the cooling system if the drained coolant is less than or equal to 0.5 Liter, otherwise fill and bleed the cooling system. Refer to COOLING SYSTEM/COOLANT - 2.0 or COOLANT, DRAINING AND FILLING - 2.9, 3.0 .
-- Check the ATF level. Refer to ATF LEVEL, CHECKING .