Overview - Input Shaft 2

Fig 1: Exploded View Of Input Shaft 2

Courtesy of AUDI OF AMERICA, LLC

Sensor Wheel
- Replace after removing
- Installation position. Refer to Figure
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Circlip
- Selecting thickness. Refer to Figure.
Thrust Washer
- For 4th gear assembly
Inner Race/Needle Bearing
- For 4th gear assembly
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Needle Bearing
- For 4th gear assembly
4th Gear Assembly
Synchronizer Ring for 4th Gear
- Replace if there are grooves or scoring
- Do not interchange with the synchronizer ring for 6th gear
Locking Collar for 4th and 6th Gears
- Installation position: the labeled side of the locking collar faces the 4th gear assembly
Synchronizer Hub for 4th and 6th Gears
- Installation position: the labeled side of the synchronizer hub faces the 4th gear assembly
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Thrust Piece
- Quantity: 3
Synchronizer Ring for 6th Gear
- Replace if there are grooves or scoring
- Do not interchange with the synchronizer ring for 4th gear
6th Gear Assembly
Needle Bearing
- For 6th gear assembly
Inner Race/Needle Bearing
- For 6th gear assembly
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Thrust Washer
- For 6th gear assembly
Input Shaft 2
- with splines for the 2nd and reverse gear
- Removing and Installing. Refer to GEAR SET, DISASSEMBLING AND ASSEMBLING .
- Disassembling and Assembling. Refer to INPUT SHAFT 2, DISASSEMBLING AND ASSEMBLING .
Circlip
- For securing on the bearing bracket
- Select and install the thickest circlip that will fit.