Lower Transverse Link
- Wind Deflector
- Equipped on some models
- Bolt
- 40 Nm + 180°
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Front Lower Transverse Link
- Removing and installing. Refer to FRONT LOWER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Installation position. Refer to Figure.
- Wind Deflector
- Eccentric Screw
- Subframe
- Nut
- Replace after removing
- Nut
- 140 Nm
- Replace after removing
- Loosen and tighten using the 21 mm twelve-point socket
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Eccentric Washer
- Rear Lower Transverse Link
- Removing and installing. Refer to REAR LOWER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Expanding Rivet
- Bolt
- 70 Nm + 180°
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Wheel Bearing Housing
- Nut
- Replace after removing
- Bolt
- 70 Nm + 180°
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .