Rear Lower Transverse Link, Removing And Installing: Removing
-- Before starting the procedure, determine the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
-- Remove the spring. Refer to SPRING, REMOVING AND INSTALLING .
-- Turn the wheel hub, until a wheel bolt hole is at the top.
-- Install the Support Device:VAS 6931/1 -A- to the brake rotor -1- using two wheel bolts -2-.
-- Position the Engine and Gearbox Jack:VAS 6931 -B- at the support device and lift the wheel bearing housing slightly, doing so will make it easier to disconnect the threaded connections.
WARNING:
Risk of accident!
- Do not lift or lower the vehicle when the engine and gearbox jack is under the vehicle.
- Do not leave the engine and gearbox jack under the vehicle any longer than necessary.
-- Disconnect the threaded connection -3-.
-- Disconnect the threaded connections -1 and 4- and remove the lower transverse link -2-.