Pedestrian Protection Center Crash Sensor -G693-, REMOVING AND INSTALLING: Removing
-- Remove the lock carrier cover. Refer to Front Bumper .
-- Remove the bolt -1-, and remove the Pedestrian Protection Center Crash Sensor -G693- -item 2- from the bumper.
WARNING:
Risk of injury due to involuntary deployment.
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Disconnect the connector -3-.
-- To do this pull out the connector lock -2-, push down -arrow-, and disconnect the connector -1- on the crash sensor.