LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2023 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Passenger Protection, Airbags, Seat Belts (Convertible) >> 69 Passenger Protection, Airbags, Seat Belts >> Battery Interrupt Igniter >> Battery Interrupt Igniter, Removing And Installing >> Installing

Battery Interrupt Igniter, Removing And Installing: Installing

WARNING:
  • Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
  • Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.

Install in the reverse order of removal while noting the following:

NOTE:

Make sure the connectors are installed all the way and engage audibly.

WARNING:

The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone in the vehicle interior when connecting the battery.

-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Check the DTC memory for the Airbag Control Module -J234- and correct any entries if necessary using the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals