Brake Lamp Switch, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

LHD vehicles:

-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

RHD vehicle:

-- Remove the plenum chamber bulkhead. Refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .

Continuation for All Vehicles:

Fig 1: Brake Lamp Switch -F- Component Location

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Remove the bolt -2- and remove the Brake Lamp Switch -F- from the brake master cylinder.